header-logo.jpg

Glass Types

glass-plate.jpg

 

Plate

Annealed Glass that is used for shop windows, large display windows and large domestic application. Thickness may vary depending on the breakage risk of the particular situation or size of pane.

glass-dbleglaze.jpg

 

Double Glazed

This product has become very popular for its insulation capability and sound deadening. Used to block street noise or factory noise in offices. This product minimises condensation. The construction is two pieces of glass with a spacer in-between sealed around the edges to form an air tight pocket. This form of glazing is very popular in Europe where the climate is colder.

glass-reflective.jpg

 

Reflective

Tinted with mirror finish ideal for use in offices or wherever privacy is necessary. This product works on light sensitivity and when used on a building exterior reduces heat in the room.

glass-mirrored.jpg

 

Mirrored

With the special mirror back coating this product can be cut and shaped to suit any opening or space. Mirrored glass comes in a range of thicknesses and can be bevelled, etched or surface treated.

glass-tough.jpg

 

Toughened

Heat treated and tempered. This glass is four to five times stronger than annealed glass of the same thickness. Used in full panel doors, sliding or hinged and particularly in overhead glazing, ballustrades, stair well glass and floor to ceiling glazing.

glass-laminated.jpg

 

Laminated

6.38 minimum laminate. Designed not to shatter, and is used in most aluminium sliding, full panel or hinged door applications.

glass-tinted.jpg

 

Tinted

This product is ideal for hot, sunny areas as it reduces fading of furniture and fittings and reduces heat. Available in a large range of colours and tint gradient.

glass-block.jpg

 

Glass Block

The standard size of these structural blocks is 190 x 190mm by 80mm. These can be used as full wall partitions or partial partitions and are supplied in a number of different patterns, tinted or coloured. These can be installed using packers or grouted between blocks. Installation using combi clips or rod strengthening can increase the load bearing and structural capabilities of the wall.